1-800-426-0877
For complete installation of a Cold Wire TIG System, you need both the Cold Wire Feeder and a TIG torch (hand held or machine mounted) with cold wire TIG capabilities. The Cold Wire TIG System works independently of a standard TIG power supply using normal TIG welding parameters.
The WF-5 has an ON/OFF switch, pilot light, pulse/continuous feed switch, pulse wire on and off timers, remote switch receptacle, delay wire start and wire retract.
Benefits:
Voltage............115V AC (220V AC 50 hz. —Special Item)
Phase.................................................................Single Phase
Frequency................................................................. 50/60 Hz.
Height..................................................................15" (38.1cm)
Width....................................................................10" (25.4cm)
Length..................................................................21" (53.3cm)
Weight.............................................................54 lbs. (17.7kg)
Motor Type........................................DC permanent magnet
Motor Rating...........................................1/3 hp at 4,000 rpm
Filler Wire Spool Size....................................... 12" (30.5cm)
Filler Wire Sizes.........................030" (.8mm),.035" (.9mm),
.045" (1.1mm), 1/16" (1.6mm)
Wire Feed Speed Range.............0–500 ipm (0–1,250cm)
Feed Time (pulsed mode)................continuously variable
Dwell Time (pulsed mode).............. continuously variable
Delay Start Time.................................continuously variable
Wire Retract Time..............................continuously variable
COLD WIRE FEEDER (WF-5)